# Editing runs from Run Planning after selection in the NextSeq 1000/2000 control software

For **Cloud** and **Hybrid** run modes on the NextSeq 1000/2000, runs are planned in Run Planning in BaseSpace Sequence Hub (BSSH) and selected from a list of planned runs in NextSeq 1000/2000 control software.

If a run planned in Run Planning must be edited after selection in the NextSeq 1000/2000 control software, exit the run setup on the NextSeq 1000/2000 control software interface and edit the planned run from Run Planning in BSSH.

* It is required to exit out of the planned run on the NextSeq 1000/2000 control software because this will release the run from the locked "Ready to Sequence" state to the editable "Planned" state in Run Planning.

\
\
\ <br>

|                                                                                                                                                                                                                                                                                                                                                                        |
| :--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------: |
| *For any feedback or questions regarding this article (Illumina Knowledge Article #3205), contact Illumina Technical Support* [*techsupport@illumina.com*](mailto:techsupport@illumina.com?subject=Question%2FFeedback%20Regarding%20Illumina%20Knowledge%20Article%20#000003205%20-%20Instrumentation%20\&body=Dear%20Illumina%20Technical%20Support,%0D%0A%0D%0A)*.* |