How to enable Wi Fi on the iSeq 100
The iSeq 100 has integrated wireless networking hardware. By default, the Wi-Fi adapter is disabled because a wired connection is recommended for the most reliable data transfer. The Wi-Fi can be enabled using the following steps. Updating to enable wireless connection requires admin privileges. Please ensure customer is logged in as sbsadmin or an account with admin privileges and not SBSuser.
Note: Wireless connectivity is intended for internet access and post-run data transfer. It is not recommend to select an output folder via wireless connection.
From the iSeq Control Software, click or tap on Menu on the top left and select System Settings

Then select the Network Access tab from the top of the menu
Select the Network Configuration button

On the Windows network & internet status screen, select Change adapter options

Enable the Wi-Fi adapter by right clicking or long pressing on it and selecting Enable

Close network connections window after Wi-Fi adapter is enabled and navigate back to Windows Network & Internet
Configure Wi-Fi as needed from within the Wi-Fi tab

For any feedback or questions regarding this article (Illumina Knowledge Article #2258), contact Illumina Technical Support [email protected].
Last updated
Was this helpful?