FAQ

Instrumentation > MiSeq > FAQ

• Can MiSeq Reagents be stored at 80°C rather than 20°C?

• Can Sequencing Analysis Viewer (SAV) be used with the MiSeq System to view primary analysis results?

• Can a MiSeq post run wash be performed every week instead of entering standby mode?

• Can a MiSeq v2 flow cell be used for sequencing with a MiSeq v3 reagent cartridge?

• Can an entire index be N padded in Miseq Reporter?

• Can an expired reagent cartridge be used for a MiSeq run?

• Can secondary analysis run on MiSeq while a run is in progress?

• Does the MiSeq verify the number of cycles in a planned run with the cycles in the reagent kit?

• How Long Does the Flow Rate Check Take During the MiSeq Pre Run Checks?

• How many cycles of sequencing can be performed with the MiSeq reagent kits?

• How many index cycles can be sequenced on MiSeq?

• How much template does the MiSeq System use?

• How to access MiSeq Reporter

• How to enable email notifications on the MiSeq

• How to stop a MiSeq run

• Is it possible to perform a primer rehybridization on a MiSeq?

• MiSeq Flow cell compatibility for v2 and v3 reagent kits

• Run setup modes for the MiSeq

• What are the MiSeq dimensions and placement requirements?

• What are the lab temperature requirements for the MiSeq?

• What are the power specifications for the MiSeq?

• What color of cap on the MiSeq flow cell container corresponds to which type of flow cell?

• What does the MiSeq status bar color mean?

• What if I did not name the sample sheet with the MiSeq reagent cartridge barcode number?

• What is the maximum read lengths and total number of cycles for MiSeq kits?

• What is the minimum PhiX amount that can be spiked into a run?

• When do quality scores appear during a sequencing run on the MiSeq?

• When is the demultiplexing summary generated for analyzed MiSeq runs?

• Which Illumina library preparation kits are compatible with the MiSeq?

• Which controls should be used when sequencing low diversity libraries on a MiSeq?