Activating TeamViewer on the MiSeq i100 Series Instruments
Last updated
Was this helpful?
Last updated
Was this helpful?
Background
The TeamViewer application is built into the instrument Control Software, allowing Illumina to provide remote support to users once they activate it. After remote support has concluded, the user can disable TeamViewer, preventing unauthorized remote access.
Enabling TeamViewer in the Control Software
From the MiSeq i100 Control Software, select the drop down menu in the top left corner, then select Remote Support.
On the Remote Support user interface (UI), select Start TeamViewer.
Once TeamViewer starts, the TeamViewer ID and passcode will display. Provide both of these to Illumina Support.
At the conclusion of the session, select Stop TeamViewer to close the connection.
Figure 1: Remote Support screen used to Start and Stop TeamViewer, as well as list the TeamViewer ID and Passcode.
Enabling TeamViewer in the Illumina Tech Support Console
If the Control Software is not accessible or cannot initialize, use the following steps to access TeamViewer using the Illumina Tech Support Console.
If the Control Software is presenting a Critical Error message that is preventing initialization, select Minimize.
Double-click to Illumina Tech Support console icon in the top left corner.
Input 1 and then press Enter.
Once TeamViewer has started, the Session ID and one-time passcode (OTP) will populate. Provide both of these to Illumina Support.
Figure 2: Illumina Tech Support Console used to activate TeamViewer when Control Software is unable to start or initialize.
For any feedback or questions regarding this article (Illumina Knowledge Article #9237), contact Illumina Technical Support techsupport@illumina.com.
