Operational Qualifications Results upload prompt at end of run on the MiniSeq
Last updated
Was this helpful?
Last updated
Was this helpful?
A prompt to upload Operational Qualifications Results can be seen on the MiniSeq with Control Software (MnCS) v2.1.0.
After completing the first run after the software version is installed, a prompt appears asking to upload Operation Qualification (OQ) results to BaseSpace Sequence Hub (BSSH). Until a selection is made, the run will still show as Analyzing in BSSH.
If the instrument is power cycled or the control software (MnCS) is exited between runs, this prompt will reappear after the next run.
These results are not critical for most users and are not required to be uploaded for the operation of the instrument. Select "Don't Ask Again" to prevent this pop-up in future runs.
For any feedback or questions regarding this article (Illumina Knowledge Article #2236), contact Illumina Technical Support .
