For the complete documentation index, see llms.txt. This page is also available as Markdown.

Troubleshooting the "Could not find a part of the path 'C:\Folder\Data\ad.bin" error in GenomeStudio Genotyping

The error "Could not find a part of the path 'C:\Folder\Data\ad.bin'" can occur when attempting to open a standalone GenomeStudio .bsc file if the accompanying Data folder is missing.

Note: The “Could not find a part of the path” error can occur in other situations. This article specifically addresses instances where the error message identifies the ad.bin file as part of the missing path.

The following image shows the correct parent folder structure for a GenomeStudio genotyping project.

The parent folder, which has the same name as the GenomeStudio project, contains the .bsc file and the accompanying Data and CNV folders.

Figure 1. Parent folder structure of a GenomeStudio Genotyping project.

The Data folder contains the necessary .bin files to open the GenomeStudio project.

Figure 2. Content of the Data folder of a GenomeStudio project.

When sharing a GenomeStudio project, share the entire parent folder rather than the .bsc file alone. The parent folder is named after the project and contains the .bsc file and the associated Data and CNV folders.

Reference:

GenomeStudio Genotyping Introduction Support Webinar Video

For any feedback or questions regarding this article (Illumina Knowledge Article #5955), contact Illumina Technical Support techsupport@illumina.com.

Last updated

Was this helpful?